Page 1
Restraint Lanyard Instruction Manual Read and understand instructions before using this equipment Do not throw instructions away Designed in the UK SHUM-067 Iss 01...
Page 2
Contents Limitations, Applications & Using the lanyard About & Warning Description Inspection General use Compatibility Standards & Connections Maintenance, Product Life Labelling Service Log Inspection Table Appropiate Servicing & & Disposal Storage Declaration Notes Notes Conformity...
If in doubt, altered or modified equipment. the product is to be used. lanyard range. contact SafeHold Ltd. for advice. product that visual deformities, been subjected to a fall, If there is reason to doubt your...
Single rebar 1.2m 1.2m 2.0m 2.0m The SafeHold Restraint lanyard is IMPORTANT Material Polyester webbing / zinc plated steel connectors deigned for use with the SafeHold Never use the lanyard with an height safety range. EN358:2018, extension device this will Standards Rfu 11.062...
As per EN355:2002, Anchorage Connectors self-locking snap hooks SafeHold equipment is designed carabiners are required. for use with SafeHold approved components subsystems only. Non-approved components or subsystems may jeopardise the CORRECT CONNECTION COMPATIBILITY Connecting component or if any connector does not lock, limitations: do not use the system.
Page 6
Pregnant women or anchorage and a full body harness required. (i.e. inspection work, Use caution when using this minors must not use SafeHold fall (SHBH), with a connecting device, general construction, maintenance equipment around moving arrest products.
Page 7
Product Life: of use, storage, maintenance, MAINTENANCE, SERVICING & STORAGE environment and regularity of use. The functional life of a restraint HSE guidelines in INDG367 must Cleaning: water to clean the fall arrest lanyard lanyard is ten years from the first be adhered to.
Labelling: SERVICE LOG See below for a typical lanyard label. All labels on the restraint lanyard must be present and fully legible. Safehold LTD www.safe-hold.com Model #: User: Date of first use: Serial No: Date of manufacture: Pass Fail Label No. 32106 (Rev. 1)
Ensure webbing is free from cuts, abrasion, wear and tears This declaration of conformity is issued under the sole responsibility of the manufacturer: SAFEHOLD LTD: 1-3 Eaves Court Bonham Drive, Check webbing under buckles for rubbing and deterioration. Sittingbourne, ME10 3RY.