Table of Contents
Advertisement
Intel Server RAID Controller U2-1 Hardware
Setup
Hardware Requirements
•
Server with CD-ROM Drive not attached to Intel Server RAID
Controller U2-1
•
One available PCI slot (33MHz recommended)
•
Monitor display resolution of 800 x 600 or higher
•
Intel Server RAID Controller U2-1 Adapter Card
•
PCI 2.2 Compliant BIOS
Installing Intel Server RAID Controller U2-1 into a System
The Intel Server RAID Controller U2-1 comes with the Intel Integrated RAID
firmware already programed into the flach memory. All that is necessary before
installing the SRCU21 adapter into the Intel server board is to install an
approved SDRAM ECC DIMM into the memory socket. Install an appropreate
DIMM into the memory socket as indicated in the diagram on the previous page.
Please refer to the approved memory list at:
http://support.intel.com/support/motherboards/server/srcu21.
WARNING
SHOCK HAZARDS may be present inside the unit in which this card
is being installed. Disconnect all power cords to the unit before
removal of any covers.
Follow the warnings noted in your computers user or service manual
before installing this board. ONLY after all the covers are reinstalled
should you reattach the power cords and power up the unit for the
software installation and use.
1
Power down the system, disconnect power cord(s) and remove the system
cover.
2
Install the SRCU21 into an available PCI slot. Connect one end of the
SCSI cable to the internal (68 pin) or external (VHDCI) SCSI connector on
the SRCU21. Connect the other end of the SCSI cable to the SCSI drives
or drive enclosure.
3
Replace the system cover, reconnect power cord(s).
NOTE
SRCU21 will work in a 66MHz slot, however, a 33MHz PCI slot is
recommended. Consult the system guide for the target server board to
determine an appropriate 33MHz PCI slot.
6
Intel Server RAID Controller U2-1 (SRCU21) Quick Start Guide
Download from Www.Somanuals.com. All Manuals Search And Download.
Advertisement
Table of Contents
