System Information; Software Upgrade; Copy Channel Data - Samsung DSR 9500AT Instructions For Use Manual

4.5 System Information

If you have to contact your service provider or a service
center they might ask for information available from this menu.
Place the cursor on this sub menu and press
The following will be the on-screen display.

4.6 Software Upgrade

You can download and upgrade the software of this
STB through ASTRA and Hotbird satellite when
the new software is released.
During downloading don't turn off the STB.
If there is a new version of software to download,
you are asked if you will update or not.
If you press key, the update starts right away.
In case update is impossible, you get this message
"You can't update software!" Or in case you don't
need to update, "You don't need to update software!" will be displayed.
If you get information that a Transponder is changed to different one for Samsung software,
you should select 'User Advanced Mode' at Menu mode by using
should set exact parameters for the new transponder for Samsung.

4.7 Copy Channel Data

If you want to copy the channel data from one receiver
to another, please follow the instruction below.
Please make your own channel data, such as favorite
& lock channel with your own master box.
Then take your master box when you install another box.
1. Plug on both master & slave receivers
2. Master Box(Installed Box) : Stand-by Mode
3. Slave Box(Installing Box) : Menu Mode
4. Connect 2 Boxes with RS232 serial cable
(Both end should have male connector)
5. Select '4. System Setup'
6. Press '7' key on RCU
7. Press 'OK' to start channel data copy
N N o o t t e e : Use this function after removing SMART CARD or CAM modules.
OPERATING THE RECEIVER
key.
GB-28
/ key. Then you
D I G I T A L S A T E L