Lnb Setting; Positioner Setting - Samsung DSR 9500AT Instructions For Use Manual

1.1 LNB Setting

You can select the satellite and LNB setting conditions
to execute channel search and you can alter the settings
for 22KHz tone. The parameters set in this menu are
needed for programming the channels for the "Auto
scanning" and "Manual scanning".
The necessary information can be found at your antenna
and LNB brochures, or you can ask your dealer.
Select LNB power supply "On".
Select the desired satellite name.
Select the LNB type (frequency).
Select the DiSEqC Mode
(Off, DiSEqC A, DiSEqC B, DiSEqC C, DiSEqC D, Tone Burst A, Tone Burst B)
If you are using a Positioner, select this option. ("Yes" or "No")
22KHz: In case you are using a dual LNB or two antennas connected to a 22KHz
tone switch box, with the 22 KHz tone switch ("On", "Off" or "Auto") you
can switch between both LNB or antennas.

1.2 Positioner Setting

If you have a DiSEqC 1.2 motorized system
which is fully compatible with DiSEqC1.2, then you can
take advantage of the DiSEqC 1.2 functions available.
Select Satellite.
Select any transponder from above satellites and
check out the Frequency, Symbol Rate, FEC and Polarity.
In case problems arise, ask your dealer.
Select from Menu Mode:
"User" mode :
"Installer" mode :
OPERATING THE RECEIVER
Enables control of basic positioner function
recommended for beginners. General user uses "User" mode.
This is used to search for the position of a satellite manually.
GB-16
D I G I T A L S A T E L