Table of Contents
Advertisement
Available languages
Available languages
OPERATING THE RECEIVER
4.5 System Information
If you have to contact your service provider or a service center
they might ask for information available from this menu.
Place the cursor on this sub menu and press the OK key.
The following will be the on-screen display.
●
Press YELLOW (ALT) key for help.
4.6 Software Upgrade
You can download and upgrade the system software of the receiver through a specific channel
through a specific channel designated by the broadcaster.
The distributor will provide you with more information about that.
If you select to download a new software version, all your previous settings, access code and
favorite channels etc. will be erased! Downloading may take a while. During downloading, don't
turn off the receiver.
●
Press YELLOW (ALT) key for help.
5. Embedded Viaccess
1) Change PIN Code:
Change the PIN Code of the Smartcard, if necessary.
2) Change Parental Rating:
Change the setting for the family filter, if necessary.
N N o o t t e e
: This service is not offered by all channels.
3) Change Lock indicator:
You can change the lock status of the Viaccess Smartcard.
4) Issuer Information:
Here you can call up all information stored on the Smartcard
by the publisher.
5) Authorization:
This option would indicate the authorization status of the Smartcard.
GB-28
D
I
G
I
T
A
L
T
E
R
R
E
S
T
TROUBLESHOOTING
Problem
Possible cause
No display LED on
Power cord
the front panel;
not plugged in correctly
No power supply
No pictures on the screen
Receiver in Standby mode;
SCART not connected tightly
to video output of television;
incorrect channel or video
output selected on television
No sound
Audio cord connected
incorrectly;
Volume level = 0;
Muting active
Remote Control does not
Batteries dead or inserted
operate directly
incorrectly
Poor picture quality
Signal strength too low
On-Screen Error Message
Antenna cable not connected
"Searching for signal"
or not tight;
incorrect position of the
antenna;
On-Screen Error Message
Receiver not yet set
"Channel data does not
exist."
DISPOSAL
The device, packaging material (e.g. Styrofoam) and the batteries must never
be disposed of with household refuse.
Please obtain appropriate information about the regulations in your community,
and dispose of all refuse in accordance with regulations at the separate
locations provided.
R
I
A
L
R
E
C
E
I
V
E
R
Solution of the problem
Power cord plug in correctly
Set receiver to "On";
Check connection and correct;
Check channel and video output and
correct (TV instruction manual)
Check connection and correct;
Increase volume on television set;
Press the MUTE key
Point remote control towards the
Receiver.
Replace batteries or insert correctly
Check the signal strength in
the "Installation" menu, correct
alignment of your antenna
Check connection and correct;
Check position and correct,
Check the signal strength in
the "Installation" menu
Scanning of in "Installation" menu
GB-29
Advertisement
Chapters
Table of Contents
