Electrical Connection - Smeg PGF32GNL Manual

Instructions for the installer

10.ELECTRICAL CONNECTION

Make sure that the voltage and capacity of the power line conform to the data
shown on the plate located under the casing. Do not remove this plate for any
reason.
The plug at the end of the supply cable and the wall socket must be of the same
type and must conform to the applicable legislation on electrical installations.
Make sure that the supply line is suitably earthed.
Pass the power supply cable through the back of the unit, taking care that it
does not touch the bottom casing of the hob or the oven (if any) installed
underneath it. Make sure that the cables follow the best route in order to avoid
any contact with surfaces exceeding a temperature of 90°.
Fit the power line with an omnipolar circuit-breaker with a contact opening gap
equal to or greater than 3 mm, in an easily accessible position close to the
appliance.
Avoid the use of adapters and shunts.
If the power cable is replaced, the cross-
section of wires in the new cable must be
2
no less than 0.75 mm (3 x 0.75 cable),
remembering that the end for connection to
the appliance must have an earth wire
(yellow/green) which is at least 20 mm
longer.
Only use a H05V2V2-F type cable or similar withstanding a maximum
temperature of 90°C. The cable must be replaced by a specialised technician
who must carry out the connection to the power grid following the diagram
below.
L = brown
N = blue
= yellow/green
The power supply cable must be replaced by an authorised service centre to
prevent any risks.
The manufacturer declines all responsibility for damage to persons or
things caused by non-observance of the above prescriptions or by
tampering with any part of the appliance.
22