Table of Contents
Advertisement
PRESET TUNING
FREQUENCY PRESETTING
Allows three stations per STATION CALL button (press once, twice,
1. Set the BAND selector buttons to either FM or AM.
2. Tune in the desired station.
¢ See the section ''DIRECT ACCESS TUNING"
for information on
reception using the Direct Access Tuning mode.
© See the section "AUTO TUNING" for information on reception using
the Auto Tuning mode.
* See the section ''MANUAL TUNING" for information on reception
using the Manual Tuning mode.
' In addition to station frequencies, the FM MODE (AUTO/MONO) can
also be preset.
3. Press the MEMORY button.
4. Press the STATION CALL button into which you wish
to preset the station.
e Press the STATION CALL button while the MEMORY
indicator is
flashing (about 5 seconds).
e Use the STATION CALL buttons (O through 9) to select a preset
channel. One press selects the 1 — 10 range, two presses 11 — 20,
and three presses 21 — 30.
[Example] If you press button
Once — STATION 3
Twice — STATION 13
Three times — STATION 23
Press a STATION CALL button within two seconds.
When the display stops flashing, the station is preset.
NOTE:
Do not press buttons while the display is still flashing.
5. Repeat steps 1 to 4 to preset additional stations.
A total of 30 AM and FM stations may be preset. When you store
a new preset, it takes the place of the previously stored station (if
any).
LISTENING TO BROADCASTS USING PRESET
TUNING
|
1. Press the STATION
CALL button into which the
desired station has been preset.
¢ When the function button is set to a function other than TUNER, it
will switch to the TUNER function automatically if one of the STATION
CALL buttons is pressed.
Tuning can be performed simply and accurately following the above
procedure.
'2. Adjust the volume and tone as desired.
e Make sure that TAPE 2 MONITOR button is turned on when using
an audio adaptor component (graphic equalizer, etc.) connected to
the TAPE 2 MONITOR jacks.
NOTE:
' The contents of the STATION CALL buttons will be retained for several
days, even if the receiver power cord is unplugged.
If a preset station has been erased, preset it again.
Last station memory
The last received AM and FM stations remain stored despite input
selector and/or POWER switching. To recall, use BAND selector buttons.
n
HOW TO USE THE CUSTOM MEMORY
STATION CALL NO.
1— 10
POP
11 — 20
ROCK
21 — 30
OTHER
1. Press the CUSTOM MEMORY button to display the
name (POP, ROCK, OTHER) you want to Memory
Scan.
Oo
0d
O
ew,
—
tT
MaMaRyY
SCAN
Q
@CcAN
;
i)
fC ch
carried out.
'
¢ Press the MEMORY SCAN button again to stop Memory Scan.
MEMORY
SCAN
QO
<ARB1369>
Advertisement
Table of Contents
