Table of Contents
Advertisement
OPERATING THE TUNER
Press the POWER switch to the ON position.
Select TUNER with the input selector button.
Be sure to turn the TAPE
2 MONITOR button off when listening to
AM or FM broadcasts.
Switch on the SPEAKERS button corresponding to the speakers
you wish to use.
FM auto stereo reception and monaural reception
Each time you press the MPX MODE button, the MONO indicator
in the display section lights or goes out.
elf an FM stereo broadcast is received when the MONO indicator
is out, the STEREO indicator lights and sound is in stereo.
elf an FM stereo broadcast is received when the MONO indicator
is lit, the sound will be monaural. If there is interference during
stereo mode reception, switch to mono. The sound will become
monaural but interference will be reduced.
TUNING INTO STATIONS
Turn the MULTI-JOG and the tuning frequency changes.
(Switch off when the GUI MODE button is on.)
Turning in a clockwise direction raises the frequency, while
turning ina counterclockwise direction lowers the frequency.
GUI MODE
SELECT
1. Use the FM/AM button to select either FM or AM.
When the "ST CALL" indicator is lit in the display, press the
SELECT button to switch it off.
2. Turn the MULTI-JOG
until you reach the frequency of a
desired station.
When astation is received, the TUNED indicator will light up.
NOTE:
The TUNED indicator may not light with broadcasts received
over long distances, or when the broadcast signals are extremely
weak.
3. Adjust the volume and tone as desired.
Auto tuning
Auto tuning is convenient when
you do not remember the
frequency of a desired station, or when you wish to find stations
that you do not normally fisten to.
Operate by remote control. (Refer to page 25.)
You can also perform Auto Tuning using GUI. (Refer to page 27.)
FREQUENCY PRESETTING
2,4
GUI MODE
MPX MODE
3
Switch off when the GUI MODE button is on.
1. Tune into the desired station.
See the section "TUNING INTO STATIONS".
In addition to station frequencies, the MPX MODE (auto
stereo mode or monaural
mode) can also be preset (FM
only).
2. Press the MEMORY
button.
The station (channel) number flashes in the display. (Memory
mode.)
3. Turn the MULTI-JOG to select the station (channel) you
want to memorize.
4. Press the MEMORY
button.
e The station (channel) number lights in the display, indicating
that it has been memorized.
elf you do not press the MEMORY button within about five
seconds after selecting a station, the memory
made
is
canceled.
5. Repeat steps 1 to 4 to preset additional stations.
A total of 30 AM and FM stations may be preset. When you
store a new preset, it takes the place of the previously stored
station (if any).
You can also preset using GUI. (Refer to page 27.)
LISTENING TO BROADCASTS USING
PRESET TUNING
Pa
MODE
(.e6d-L
JS
@00)|
°
(.e6d-L
JS
@00)|
SISO
9)
O}W
Switch off when the GUI MODE button is on.
1. Press the SELECT button.
The "ST CALL" indicator lights in the display and the node
switches to station call.
2. Turn the MULT!-JOG to select a station.
3. Adjust the volume and tone as desired.
When operating by remote control, press the ST +/— buttns to
select
a memorized station. (Refer to page 25.)
With GUI, you can also select preset channels. (Refer to pag 27.)
17
<ARBOS1>
Advertisement
Table of Contents
