Operating The Tuner; Tuning Into Stations Wsccsscsessseessiscetserceratsen A; Preset Tuning - Pioneer VSX-604S Operating Instructions Manual

OPERATING THE TUNER
Press the POWER switch to the ON position.
Select TUNER with the input selector.
Be sure to turn the TAPE 2 MONITOR button OFF when
listening to AM or FM broadcasts.
Switch ON the SPEAKERS button corresponding to the
speakers you wish to use.
FM auto stereo reception and monaural reception
Each time you press the MPX MODE button, the MONO
indicator in the display section lights or goes out.
- lf an FM stereo broadcast is received when the MONO
indicator is out, the STEREO indicator lights, and sound is
in stereo.
* {f an FM stereo broadcast is received when the MONO
indicator is lit, the sound will be monaural. If there is
interference during stereo mode reception, switch to mono.
The sound will become monaural but interference will be
reduced.
TUNING INTO STATIONS
Turn the multi-jog, and the tuning frequency changes. (Switch
off when the GU! MODE button is on.)
Turning in a clockwise direction raises the frequency, while
turning in a counter-clockwise direction lowers the frequency.
1 2 3
HW... soooob of
ede L__]
1. Use the FM/AM button to select either FM or AM.
Confirm that the JOG MODE indicator in the display shows
"FREQ".
If "ST" is displayed, press the SELECT button to switch to
"FREQ".
PRESET TUNING
Switch off when the GUI MODE button is on.
1. Tune into the desired station.
See the section "TUNING INTO STATIONS". In addition
to station frequencies, the MPX MODE (auto stereo mode
or Monaural mode) can also be preset (FM only).
2. Turn the multi-jog until you reach the frequency of a
desired station.
When a Station is received, the TUNED indicator will fight up.
NOTE:
The TUNED indicator may not light with broadcasts received over
long distances, or when the broadcast signals are extremely
weak.
3. Adjust the volume and tone as desired.
Auto tuning
Auto tuning is convenient when you do not remember the
frequency of a desired station, or when you wish to find
stations that you do not normally listen to. Operate by remote
control. (Refer to page 23.)
You can also perform Auto tuning GUI. (See page 25.)
2. Press the MEMORY button.
The station (channel) number flashes in the display.
(Memory mode)
3. Turn the multi-jog to select the station (channel]} you
want to memorize, and press the ENTER button.
* The station (channel) number lights in the display,
indicating that it has been memorized.
: If you do not press the ENTER button within about five
seconds after selecting a station, the memory mode is
canceled.
4. Repeat steps 1 to 3 to preset additional stations.
A total of 30 AM and FM stations may be preset. VWwhen
you store a new preset, it takes the place of the previously
stored station (if any).
You can also preset using GUI. (See page 25.)
17
<ARB7022>