Table of Contents
Advertisement
PRESET TUNING
FREQUENCY PRESETTING
Allows
three
stations
per STATION
CALL
button
(press once,
twice, or three times to select).
5
4
3
1. Press the POWER switch to the ON position.
NOTE:
Be sure to turn the TAPE 2 MONITOR button OFF when listening
to AM or FM broadcasts.
2. Set the BAND selector to either FM or AM.
3. Tune in the desired station.
® See the section "DIRECT ACCESS TUNING?" for information on
reception using the Direct Access Tuning mode.
¢ See the section "AUTO TUNING?" for information on reception
using the Auto Tuning mode.
* See the section "MANUAL TUNING" for information on recep-
tion using the Manual Tuning mode.
in addition to station frequencies, the MPX MODE (AUTO/MO-
NQ) can also be preset.
4. Press the MEMORY
button.
° The MEMORY
indicator will flash.
5. press the STATION CALL button into which you
wish to preset the station.
® Press the STATION CALL button while the MEMORY indicator
is flashing (approx. 5 seconds).
® Use the STATION
CALL buttons
(«1
—
*9, #0) to select a
preset channel. One press selects the 1 — 10 range, two press-
es 11 —
20, and three presses 21 — 30.
[Example] If you press button |*3}:
Once — STATION 3
Twice — STATION 13
Three times ~ STATION 23
Press a STATION CALL button within two seconds.
When the display stops flashing, the station is preset.
NOTE:
Do not press buttons while the display is still flashing.
6. Repeat steps 2 to 5 to preset additional stations.
A total of 30 AM and FM stations may be preset. When you store
anew preset, it takes the place of the previously stored station {if
any).
11
<ARB1439>
LISTENING
TO
BROADCASTS
USING
PRESET TUNING
(eRe al
roe]
TT
1. Press the POWER switch to the ON position.
2. Press the STATION CALL button into which the
desired station has been preset.
e When
the Function
button is set to a function other than
TUNER,
it will switch to the TUNER function automaticaily if
one of the STATION CALL buttons is pressed.
Tuning can be performed sirnply and accurately following the
above procedure.
3. Adjust the volume with the VOLUME control and
the tone with the GRAPHIC EQUALIZER controls.
NOTE:
The contents of the STATION CALL button will be preserved for
several days, even if the receiver power card is unplugged.
if a preset station has been erased, preset it again,
Last station memory
The
last received
AM
and
FM
stations
remain
stored despite
FUNCTION and/or POWER switching. To recall, use BAND selec-
tor buttons,
Advertisement
Table of Contents
