Table of Contents
Advertisement
Instructions for the installer
Carefully position the supplied insulating seal on the outer perimeter of the hole
made in the counter top as shown in the figures below, trying to make it stick on
the entire surface by applying light pressure on it with your hands. Depending on
the hob model being installed refer to the dimensions in the figure, bearing in
mind that for both models the long front side must brush against the hole. Fix the
hob to the unit using the appropriate brackets A supplied. Carefully trim the
surplus away from edge B beyond the seal. The dimensions given in the
following drawing refer from the hole to the inside of the seal.
The figure to the side shows the exact
holes to be used to correctly attach
the hob to the work surface with
brackets.
IMPORTANT: If installing the hob over an oven, ensure that the latter is
equipped with a cooling fan.
39
Advertisement
Table of Contents
