Table of Contents
Advertisement
10. ADAPTATION TO DIFFERENT TYPES OF GAS
Before carrying out the following operations, disconnect the appliance from the
power supply
The hob is preset for natural gas G20 (2H) at a pressure of 20 mbar. If other
types of gas are to be used, the nozzles must be replaced and the primary air
must be adjusted.
In order to replace the nozzles and adjust the burners, the hob top must be
removed as described below.
10.1 Removing the hob top
Remove all the burner components, following the numerical sequence in the
figures below:
•
Take out all the knobs (1) by pulling them upwards (Fig. 1);
•
Remove the grills (2), by lifting them upwards;
•
Lift all the burner components off the hob (3 - 4);
•
Undo the 10 screws (5) securing the rings (6) to the burner supports; in this
operation remove the seal underneath (7);
•
after having removed all the afore-mentioned components, lift the hob top to
access the burners and gas taps (Fig. 2).
Fig. 1
Fig. 2
20
Instructions for the installer
Advertisement
Table of Contents
