Culligan Platinum Plus Series Owner's Manual page 15

Loading the Tank (12", 14" and 16"
Tanks)
1. Position the tank so that the Culligan
2. Remove the inlet strainer.
3. Install the outlet manifold into the tank (Figure 2).
4. Cover the top of the manifold with a clean rag.
5. Using a large-mouth funnel, load the Culligan underbedding
through the top of the tank.
Caution! DO NOT allow the outlet manifold
to move when loading the media. The manifold
must remain vertical to ensure a good seal at
the gasket. Rap the tank near the bottom with a
rubber mallet to level the sand.
6. Aqua-Sensor Installation (optional device)
®
A. Measure the sensor cable length as shown in Figure 2
and Table 1 (the Aqua-Sensor
for a 9" tank).
B. Loosen the small Aqua-Sensor
works best (figure 3).
C. Moisten the cable sheath and slide the cable grip up or
down to the proper cable length.
D. Tighten the small Aqua-Sensor
cannot slide along the cable.
Note: There must be no kinks or bends in the cable.
E. Insert the probe and cable through the Aqua-Sensor
port.
7. Load the tank with the Cullex
not required. Remove the funnel.
8. Install the inlet strainer making sure to thread the strainer in
until it bottoms out on the thread. Failure to install the strainer
correctly can cause the control to leak.
Dimension "X" is the exposed length the Aqua-Sensor
length from the Aqua-Sensor
You can then verify the Aqua-Sensor
proper depth by confirming dimension "X" is at the corrected
length.
Model
10" Quadra-Hull Tank
™
12" Quadra-Hull Tank
™
14" Quadra-Hull Tank
™
16" Quadra-Hull Tank
™
logo is in the front.
®
cord is set at the factory
®
Plug, a needle-nose pliers
®
plug so that the fitting
®
ion exchange resin. Leveling is
®
cord (cord
®
plug to the circuit board connector).
®
probe is inserted to the
®
X
30 1/2"
32 1/2"
22 1/2"
22 1/2"
Table 1
Figure 2
Small
Aqua-Sensor
Plug
®
Figure 3
Y
44"
42"
52"
52"
Installation
(cont.)
®
11