Table of Contents
Advertisement
50 TROUBLESHOOTING
Parts & Features
Problem
Oven control beeps
and displays any F
code error.
k
is on in the display
when you want to
cook
Oven light does not
work.
Cooling fan
continues to run
after oven is turned
off.
Oven will not Self
Clean.
Oven door does not
open after a Self
Clean cycle
The oven is not clean
after a Self Clean
cycle
Convection fan stops
(On some models)
Displayed time is
flashing (On some
models)
Oven racks are
difficult to slide (On
some models)
Electronic control has detected a fault condition.
• Turn off the oven function you are using to clear the display and stop beeping. Reprogram
oven. If fault recurs, record fault number and call for service.
- [Case 1 ]
Code: F-9
Cause: Oven not heating (upper oven)
- [Case 2 ]
Code: F-19
Cause: Oven not heating (lower oven)
The oven door is locked because the temperature inside the oven has not dropped
below the locking temperature.
• Press the STOP button. Allow the oven to cool.
It is time to replace the bulb or the bulb is loose.
• Replace or tighten bulb. See "Changing the Oven Light" section in this Owner's Manual.
The fan turns off automatically when the electronic components have cooled
sufficiently.
• This is normal.
The oven temperature is too high to set a Self Clean operation.
• Allow the appliance to cool and reset the controls.
Oven controls improperly set.
• See the Self Clean section.
A Self Clean cycle cannot be started if oven door is open.
• Close the oven door.
Oven is too hot.
• Allow the oven to cool below locking temperature.
The control and door may be locked.
• Allow about one hour for the oven to cool after the completion of a Self Clean cycle. The
door can be opened when the lock
Oven controls not properly set.
• See the Self Clean section.
Oven was heavily soiled.
• Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens may need to
Self Clean again or for a longer period of time.
Convection fan stops during a convection bake cycle. This allows for more even heating
during the cycle.
• This is not a failure of the range and should be considered normal operation.
This means that the product has just been plugged in, or that it has experienced a
power interruption.
• Press the Clock key and reset the time, or press any key to stop the flashing.
The shiny, silver-colored racks were cleaned in a Self Clean cycle.
• Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven
racks with the paper towel.
Possible Cause & Solution
k
is no longer displayed.
Advertisement
Table of Contents
