Table of Contents
Advertisement
Installation
Model 11713A
1
,—^ t-(
IFUSE
PUIL
SELECTiON OF OPERATING VOLTAGE
1. Open cover door and rotate fuse-puli to left.
2. Select operating voltage by orienting PC board to position desired voltage
on top-left side. Push board firmly into module slot.
3. Rotate fuse-pull back into normal position and re-insert fuse in holders,
using caution to select correct fuss value.
-WARI\II-NG=
-^Po^i^@i^tke'^-o^-i'b'i-U4y=@f^^archm-^leeiriesyshockfdt>-^-t-opeT''^-
ate this instrument at line voltages greater than 126.6 Vac with line
frequencies
^reefer
than 66 Hz (leakage currents at these line settings
may exceed 3.5 mA).
M *J UMMa! A41.1 *.M' . *» R b 1 1 >A. tiUU
:
Figure 2-1. Line Voltage Selection
2-2
Figure 2-2. Power Cable and Mains Plug Part Numbers
Advertisement
Table of Contents
