Toshiba TDP ET20/U Owner's Manual page 45

Using menus (Continued)
Advanced MENU
Overscan
Adjust overscan ratio of the image.
Press . Adjust with
No overscan when set to 100%
NTSC mode
Set the black level for video/s-video input.
Press . Select US(7.5IRE)/Japan(0IRE) with
This can be adjusted only when video input source is video/s-video and input signal is
NTSC or NTSC4.43.
HDMI mode
Set the black/white level for HDMI input.
Press . Select HDMI/DVI with
This can be adjusted when input source is HDMI.
Frequency
Adjust the sampling frequency to eliminate periodic patterns and flickering when many
vertical lines appear on the screen.
Press . Adjust with
This can be adjusted when input source is Computer.
Phase
Adjust the sampling phase to eliminate flicker.
Press . Adjust with
This can be adjusted when input source is Computer.
Mpeg NR
Adjust the detail of noise reduction. Mpeg noise reduction level.
Press . Adjust with
Reset
Reset Advanced picture setting MENU adjustments and settings to factory default.
Press . Confirmation window will appear and select [Yes] with
and press to reset.
/ [ - ] (Lower) or
/ [UP] [DOWN] key.
/ [ - ] or / [ + ] key.
/ [ - ] or / [ + ] key.
/ [ - ] (Lower) or
/ [ + ] (Higher) key.
/ [UP] [DOWN] key.
/ [ + ] (Higher) key.
44
/ [ - ] or / [ + ] key