Placement - Toshiba TDP ET20/U Owner's Manual

Placement

Placement Styles
This device can be placed in some different placement styles. The factory setting is "floor-
mounted front projection" although you can modify the setting according to your needs.
Set the Projection mode in accordance with your needs through remote control or control
panel, enter SETUP menu.
Floor-mounted front projection (Standard)
Ceiling-mounted front projection (Ceiling)
TDP-ET10 only
Floor-mounted rear projection (Rear)
Ceiling-mounted rear projection (Rear Ceiling)
TDP-ET10 only
WARNING
• Always obey the instructions listed in the IMPORTANT SAFETY INSTRUCTIONS
section of this manual when setting up the unit. Attempting to clean/replace the lamp at
a high site by yourself may cause you to fall thus resulting in injury.
• If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so.
Mounting the projector on a ceiling requires special ceiling brackets (sold separately)
and specialized installation knowledge. Improper mounting could cause the projector to
fall resulting in a serious injury.
• If the projector is ceiling-mounted, install the breaker for turning off the power in case of
anomaly. Let everyone involved with the use of the projector know that fact.
■ Note
In order to avoid image distortion, place the projector at flat platform, the slope should not
over 20 degree. Surface of projection screen or wall should be flat and neat.
22