Toshiba TDP ET20/U Owner's Manual page 28

■ Using standby mode to save power and turning the power off
Put the Projector into standby mode to save power.
1
Pressing the ON/STANDBY button once, a power off indication message will appear.
Press the ON/STANDBY button to put the projector into standby mode. The power off
message has to be displayed for the second press of the power button to be valid.
The cooling fan will operate for about 60 seconds. In this state the power cannot
A
be turned back on.
B
In Standby mode. The ON/STANDBY indicator (Blue LED) is flashing.
Press power switch to turn the power off.
2
Press the main power switch on the terminal panel to turn off the projector.
■ Note
• The projector consumes about 4W of power in standby mode. We recommend that
you unplug the power cord or turn off the main power switch if you will not be using the
projector for an extended period.
■ PRECAUTION
• If the power cord is unplugged before cooling is complete, give the lamp time (about 5
minutes) to cool before plugging it back in. If the lamp overheats, it may fail to light.
When cooling lamp
Red: blink
A
Blue: on
After cooling complete

Red: off
B
Blue: blink
27