Display" Off Status; Networking; Miele@Home; Smartgrid - Miele TWV 780 WP Operating Instructions Manual

Settings

"Display" off status

To save energy the display and sensor
controls will go out after 10 minutes
and the Start/Stop button will flash
slowly. You can change this setting.
Options
-
On
The display will go out (after
10 minutes):
– if a programme is not selected
after the dryer has been switched
on
– while the programme is running
– after the end of a programme
-
On. Not in current prog.
(Factory default)
The display will go out (as described
above) but will remain on while the
programme is running.
You can switch the display back on by
touching any sensor.

Networking

Miele@home

Control the networking of your tumble
dryer with your home WiFi network.
The following points may appear in the
submenu:
Set up
This message only appears if the tumble
dryer has not yet been connected to a
WiFi network.
Please refer to "Before using for the first
time" for instructions on how to set up
the connection.
Activate
(visible if Miele@home is deactivated)
The WiFi function is reactivated.
94
Deactivate
(visible if Miele@home is activated)
Miele@home remains set up, the WiFi
function is switched off.
Connection status
(visible if Miele@home is activated)
The following values are displayed:
- The quality of WiFi reception
- The network name
- The IP address
Set up again
(visible if set up)
Resets the WiFi login (network) to im-
mediately re-establish a new connec-
tion.
Reset
(visible if set up)
- The WiFi is switched off.
- The WiFi connection will be reset to
the factory default setting.
The network configuration should be re-
set whenever a tumble dryer is being
disposed of or sold, or if a used tumble
dryer is being put into operation. This is
the only way to ensure that all personal
data has been removed and the previ-
ous owner will no longer be able to ac-
cess the tumble dryer.
A new connection setup has to be car-
ried out in order to use the
Miele@home setting again.

SmartGrid

The setting is only visible if
SmartGrid
the
Miele@home
activated.
setting is set up and