Use a damp cloth to remove any fluff
from the handle.
Fit the plinth filter back on the handle.
Make sure it is the correct way round.
Push the plinth filter in completely.
This will push in the right-hand guide pin
at the same time.
Cleaning and care
Cleaning the plinth filter access panel
Use a damp cloth to remove any fluff.
Make sure that you do not damage
the rubber seal when doing this.
Close the heat exchanger access
panel.
Damage or ineffective drying if
drying takes place without a plinth fil-
ter or when the heat exchanger ac-
cess panel is open.
An excessive accumulation of fluff
can damage the tumble dryer. If the
system is not leak-tight, this can
make drying ineffective.
Only operate the tumble dryer with
the plinth filter fitted and the heat ex-
changer access panel closed.
59