Shimadzu ECD-2010 Exceed Instruction Manual page 6

Introduction
n Repair, Disassembly and Modification
n Corrosive gas and dust
The vital section of the measuring circuit of this detector is shielded in a case.
In view of maintaining the service life and accuracy of the detector, avoid installing in
a dusty or corrosive environment.
n Discharge of carrier gas
Connect a vinyl or teflon tube to the exhaust port (VENT) when using the detector, and
set the other end of the tube on the roof of the building or other place where no
person is likely to come within 1 m from the tube end.
n Precautions on unit removal
DO NOT remove or disassemble the ECD detector. When it is necessary to remove the
ECD, contact your Shimadzu representative.
iv
ECD-2010 Exceed
Do NOT modify or disassemble the product without permission.
This may result in accidents due to electric shock or short circuits. It may also
result in an injury or equipment failure.
When repair is necessary, request your Shimadzu representative.
Failing to do so may result in an ignition, electric shock, or injury.