Mail Setting - Fujitsu UTY-DCGYZ3 Operation Manual

3-5-8. Mail Setting
Sets the mail address destination when "Error notification" or "Room temperature notification" is sent.
(3)
(1)


3-5-8-1. Mail Setting


3
(2)
4
5

3
(1) Tap the MENU button.
(2) Tap the [Installer Setting].
(3) Tap the [Mail Setting].
(4) Select the setting function.
No. Item
Performs the mail account setting, etc.

"Mail Setting"


→Refer to 3-5-8-1.
"Server Performs the mail server connection

Setting" setting.→Refer to 3-5-8-2.
* After the Server Setting is performed, perform the Mail
setting.
(1) Set the item and tap the [OK] button.
No. Item
"Error

notification"
"Email Address"

"Transmission
3
Test"
"Room
temperature
notification"
4
("Lower Limit")
(*2)
"Room
temperature
notification"
5
("Upper Limit")
(*2)
(*1) If sending mail is failed, the failure reason of sending is
displayed. When a mail server error is displayed in failure
reason message, contact the mail server management
company. For other messages, check the appropriate
settings in this controller.
(*2) For room temperature notification, wired remote controller
must be connected to the indoor unit and remote sensor
must be enabled.
For the setting method, refer to the remote controller
manual.
* If the server setting is not correct, mail is not sent. For details,
refer to your mail service.
Description
Description
Sets "Enable" or "Disable" of mail
notification when an error occurs.
Sets the mail address destination
when "Error notification" or "Room
temperature notification" is sent.
Performs "Transmission test" to send
the notification mail.
Transmission result display:
"Failed sending mail."(*1) / "Mail sent."
Sets the room temperature lower limit
for sending a mail.
"Lower limit": -15.5ºC
Sets the room temperature upper limit
for sending a mail.
"Upper limit": 63.5ºC
En-47