Clean It; Plug It In; Locate Properly; Level Refrigerator-Freezer - KitchenAid Superba KSRS22Q Use And Care Manual

Indalling ike Refrigerator-Freezer
Clean It
Clean your refrigerator before using
it. See cleaning instructions on page
18
.
Remove the Consumer Buy Guide
label and any shipping tape before
using the refrigerator.
To remove any remaining glue:
1. Rub briskly with thumb to make a
ball, then remove.
OR
2. Soak area with liquid hand
dishwashing detergent before
removing glue as described in
step 1.
IMPORTANT: DO NOT USE sharp
instruments, rubbing alcohol,
flammable fluids or abrasive
cleaners. These can damage the
material. See "Important Safety
Instructions" on page 3.
DO NOT REMOVE THE
INSTRUCTION LABEL FOR SETTING
THE CONTROLS INSIDE THE
REFRIGERATOR.
DO NOT REMOVE the Tech Sheet
fastened under the refrigerator,
behind the base grille.
Plug It In
3-prong grounding
Recommended grounding method
Alls Volt, 60 Hz., AC only, 1 5 or
20 Amp fused and properly
grounded electrical supply is
required. It is recommended that a
separate circuit serving only this
appliance be provided.
Do not use an extension cord.
Use a receptacle which cannot
be turned off with a switch or
pull chain. See Electrical
Requirements and Grounding
Instruction Sheet in your Literature
Package.
Locate Properly
1. Allow 1/2 inch (1.25 cm) on
each side of the refrigerator for
ease of installation.
2. If the refrigerator is to be against
a wall, you might want to leave
extra space on the hinge side so
the door can be opened wider.
3. The refrigerator back can be flush
against the wall.
Level Refrigerator-Freezer
1. Remove base grille. (See page 10.)
2. To raise front, turn each screw
clockwise.
3. To lower front, turn each screw
counter-clockwise.
4. Check with level.
6