Furuno FAR-2018-MARK-2 Operator's Manual page 25

5) For configurations with 3 or more radars/ECDIS (FMD-3100/FMD-3200/FMD-3300) connect-
ed, connect via the HUB-3000. For 2 radars, HUB-100 can be used.
6) For connection to a VDR or IEC61162-450 Ed.2 sensor, connection should be made via the
HUB-3000.
7) Some antenna configurations do not have an in-built Performance Monitor. This type of anten-
na is not usable for IMO-type radars.
8) For connecting non-FURUNO ECDIS only. For connection of radars or plotters, the connection
must be done at the radar antenna (or the transceiver unit) via the sub monitor connector.
9) Available only for A/B/W-types with Radar Plotter functionality.
10) Junction boxes are required for antenna cable length greater than 100 m (only for TX-band R-
UP radar). Max. cable length is 400 m.
11) Unavailable on IMO-type radars.
SYSTEM CONFIGURATION
xxiii