Interruption A Program; Changing A Program; Annulling A Program - Smeg DC122B Instruction Manual

INTERRUPTION A PROGRAM

To interrupt a program in progress:
•
press the START/PAUSE button (3 ) for a few seconds; the light of
the phase in progress remains on and the light of the program in
progress flashes (confirmation beep);
•
you may now restart the program by pressing button (3) again until it
restarts, or change or annul the program (see "C
PROGRAM

CHANGING A PROGRAM

To change the running program it is necessary:
•
to interrupt the running program (see "I
•
select the new program;
•
start the program (see "S

ANNULLING A PROGRAM

To annul the program
•
press the START/PAUSE button (3 ) for a few seconds; the light of
the phase in progress remains on and the light of the program in
progress flashes (confirmation beep);
•
Keep the START/PAUSE button (3) pressed until the PROGRAM
PHASES lights (5) go out (confirmation beep). The lights of
programs 4 and 5 come on.
The water in the tank will be pumped out and the program will end at the
point where it was interrupted. When the operation is complete, the
PROGRAM PHASES lights (5) flash.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph "
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
18
User instructions
", or "A
NNULLING A PROGRAM
TARTING THE PROGRAM
S
TARTING THE PROGRAM
").
NTERRUPTION A PROGRAM
").
". The program will resume from the
HANGING A
");