The contents of this guide may be updated or revised due to product development. The information in this guide is subject to change without notice. The latest version of this document and the manual for installation, commissioning, configuration and decommissioning are to be found in PDF format at www.solplanet.net. Safety Intended use...
Page 3
The product must only be used in countries for which it is approved by AISWEI and the grid operator. The type label must be permanently attached to the product and must be in a legible condition. This document does not replace any regional, state, provincial, federal or national laws, regulations or standards that apply to the installation, electrical safety and use of the product.
Page 4
DANGER Danger to life due to electric shock when touching live components in backup mode! Even if the AC breaker and the PV switch of the inverter are disconnected, the parts of the system may still be live when the battery is switched on due to backup mode. Do not open the product.
Page 5
DANGER Danger to life due to electric shock when touching live system components in case of a ground fault! If a ground fault occurs, parts of the system may still be live. Touching live parts and cables may result in death or lethal injuries due to electric shock. Disconnect the product from voltage and energy sources and ensure it cannot be ...
Page 6
Symbols on the label Beware of a danger zone! This symbol indicates that the product must be additionally grounded if additional grounding or equipotential bonding is required at the installation site. Beware of high voltage and operating current! The inverter operates at high voltage and current. Work on the inverter must only be carried out by skilled and authorized electricians.
AISWEI Technology Co., Ltd. confirms herewith that the products described in this document are in compliance with the fundamental requirements and other relevant provisions of the above mentioned directives. The entire EU Declaration of Conformity can be found at www.solplanet.net. Overview Object...
Page 16
Unit:mm icon Connector number Line color brown black grey blue yellow-green 12 EPS Load Connection QG0049_ASW05-12kH-T2-T3_EN_540-300254-04_V04_0324...
15 Communication Setup 15.1 Communication connection PIN definition Object Description Terminal RJ-45-3 Monitor COM2 RS485A RS485B GND RS485A RS485B RJ-45-4 COM5 CANAH CANAL RS485A RS485B PIN definition Object Description Terminal NS-protection (network Smart Meter and system protection) Terminal-2 6pin Device RS485A...
Page 21
Ripple Control Receiver Device DRMS Device Terminal-3 DI*4/DRM0 6pin LOAD/0 DI_4 DI_3 DI_2 DI_1 REF GEN/0 or GND Current Transformer Current Transformer Current Transformer L1(U) L2(V) L3(W) Terminal-4 6pin Black Black Black QG0049_ASW05-12kH-T2-T3_EN_540-300254-04_V04_0324...
Page 22
15.2 Current Transformer connection (optional) QG0049_ASW05-12kH-T2-T3_EN_540-300254-04_V04_0324...
Page 23
15.3 Smart meter connection (optional) QG0049_ASW05-12kH-T2-T3_EN_540-300254-04_V04_0324...
Page 25
——Inverter model ——Inverter serial number ——Photovoltaic module model ——Photovoltaic modules number and strings number connected to each MPPT ——Fault code ——Installation location EMEA Service email: service.EMEA@solplanet.net APAC Service email: service.APAC@solplanet.net LATAM Service email: service.LATAM@solplanet.net Aiswei Greater China Service email: service.china@aiswei-tech.com...
Need help?
Do you have a question about the ASW06kH-T2 and is the answer not in the manual?
Questions and answers