Water Connection - Smeg CWC601D Manual

4 INSTALLATION INSTRUCTIONS FOR THE AFTER-SALES SERVICE

4.1 Water connection

Water supply and drain connection:
The water pipelines and electricity supply cable lead out of the bottom
right-hand corner of the appliance. Connect the water intake hose to a
connector with ¾" gas threaded fitting, fitting the filter A provided.
The connection to the water mains must only be made with new hoses; the
use of old or worn hoses is not permitted.
An `approved` single check valve or some other no less effective device providing backflow prevention
protection to at least fluid category two shall be fitted at the point of connection between the water
supply and the fitting or appliance.
The dynamic intake pressure must be between 1 and 6 bar; if it is higher, installation of a pressure reducer is
recommended.
It is essential to fit a main stop tap on the water intake pipeline; the tap must be accessible after installation of
the appliance, so do not install it behind the dishwasher.
The stated cycle duration refers to appliances supplied with hot water at 50°C.
If the appliance is supplied with cold water, the cycle duration might increase depending on the intake water
temperature, since the dishwasher is fitted with the HTR system, which requires set temperature and pressure
for rinsing.
Drainage:
The dishwasher is fitted with a drain pump and can operate with drain
connections on the floor or wall.
Caution: make sure that the intake and drain hoses are not bent,
constricted or crushed after installation.
If the drain connection is to an outlet with valve, the maximum height of the drain is reduced to 600 mm.
In all cases, after installation check that the drain is fully functional by pumping out the tank completely (P0
cycle).
5