Table of Contents
Advertisement
WARNINGS
The appliance is to be used for washing baking trays, ice cream basins, baking tins, saucepans
and kitchen utensils.
Read the instructions carefully before installation, use and maintenance of the appliance.
The installation has to be performed by qualified personnel following the manufacturer's
instructions given in the provided manual.
The appliance should only be used by trained personnel.
In the event of breakdown or malfunction, switch off the appliance and seek help exclusively
from an authorized technical assistance centre.
The manufacturer declines any liability for damages to persons or things caused by the non-
compliance with the instructions of this manual, by non-correct use, by the alteration of any
part of the appliance and by the use of non-original spare parts.
INSTALLATION
Noise level <70 dB (A)
WATER CONNECTION
The appliance installation requires the connection of hydraulic flexible pipes, supplied together with
the appliance and in particular:
3/4" water supply hose GAS;
Ø1½ " drain hose.
Except for models with built-in drain pump, connect the drain hose of the appliance to a suitable
drain waste system, through a siphon on the floor near the appliance itself. Connect the filling pipe
with a 3/4" GAS water supply protected by an interception valve.
Before proceeding with the water connection, check the following conditions:
The water supply pressure, measured with open valve, has to vary between 1 and 4 bars. If the
water supply pressure is lower than 1 bar, install a booster pump with delivery of 30 litres/min; if
it is higher than 4 bars, a pressure reducer set at 4 bars maximum has to be installed.
The water hardness has to be between 8° and 14° F (0,8 - 1,4 mmol/l). If the water is harder,
install a water softener suitable for the water quantity used by the appliance containing 16 litres
of resin at least.
WARNING: If the appliance works continuously with short cycles, it is necessary to connect
the appliance to hot water at 50° C.
ELECTRIC CONNECTION
The machine is not supplied with a plug: it has to be connected to the electric mains only by
qualified personnel through a main switch with circuit breaker on the wall, suitable for the
maximum power installed, in order to have the possibility to exclude the appliance from the electric
mains during the preliminary operations or the maintenance. When not in use, it is highly
recommended to always disconnect the appliance from the electric mains.
The appliance has to be connected also to a equipotential system of compensation through a screw,
placed on the lower part of the appliance back and marked
The appliance is conceived to work under the following specifications:
400 V (3N) 50 Hz
230 V (3N) 50 Hz
.
23
Advertisement
Table of Contents
