Malfunctions Shown On The Display (For The User) - Smeg CW510 Manual

10 MALFUNCTIONS SHOWN ON THE DISPLAY (FOR
The dishwasher is able to identify a number of malfunctions and show them on the display.
If the problem persists after the dishwasher has been switched off and back on, proceed as described
below:
E.1 Boiler temperature probe malfunction
E.2 Tank temperature probe malfunction
E.3 Water intake malfunction
E.4 Boiler overheating.
E.5 Tank overheating
E.6
Water not pumped out of tank
‐ CW 510/D/SD
CW 510M/MD/MSD
THE USER)
Switch the dishwasher off and back on and perform
another cycle; if the problem persists call the after‐
sales service.
Switch the dishwasher off and back on and perform
another cycle; if the problem persists call the after‐
sales service.
Water intake not completed in the maximum time
allowed
Check dynamic pressure in intake system: the water
intake filter may need cleaning, the tap may be
turned off or the rinsing nozzles may be fouled.
Switch the dishwasher off and back on and perform
another cycle; if the problem persists call the after‐
sales service.
Switch the dishwasher off and back on and perform
another cycle; if the problem persists call the after‐
sales service.
Inspect the filters for dirt and check that the drain
hose is not blocked, bent or crushed.
Check that the drain pump is not blocked by dirt by
removing the insert on the sump (from inside the
tank)
If the problem persists:
‐ with tank empty: tank pressure switch has failed
(continuous full reading)
‐ with tank full: drain pump failure
If the system fails to pump out because the drain
pump is fouled (as a result of incorrect filter
positioning), proceed as follows:
Bale out the dishwasher with a basin and disconnect
it from the electrical mains.
Unscrew the screw A, release the tang B and lift it.
Check that the impeller of the drain pump
underneath the cover turns freely, and is free from
dirt, limescale residues, or pieces of glass. Never use
30