Table of Contents
Advertisement
Service Parts
Indoor Air Filter
1. Remove any dust adhered on the lter by using a vacuum cleaner
2. Rinse well and dry the lter before placing it back onto the unit.
3. Do not use gasoline, volatile substances or chemical to clean the lter.
Indoor Unit
1. Clean any dirt or dust on the grille or panel by wiping it using soft
2. Do not use gasoline, volatile substances or chemical to clean the
Indoor Fan
1. Check for any abnormal noise.
Avoid direct contact of any coil treatment cleaners on plastic part. This may cause plastic part to deform as a result of
chemical reaction.
For any enquiries on spare part please contact your authorized dealer. When any malfunction of the air
conditioner unit is noted, immediately switch off the power supply to the unit. Check the following fault
conditions and causes for some simple troubleshooting tips.
Fault
1. The compressor does not start operate after 3 minutes from
starting the air conditioner unit.
2. The air conditioner unit does not operate.
3. The air ow is too low.
4. Discharge air ow has bad odor.
5. Condensation on the front air grille of the indoor unit.
6. Water owing out from the air conditioner unit.
If the fault persists, please call your local dealer / serviceman.
SERVICE AND MAINTENANCE
Maintenance Procedures
or wash in lukewarm water (below 40°C) with neutral cleaning
detergent.
cloth soaked in lukewarm water (below 40°C) with neutral detergent
solution.
indoor unit.
! CAUTION
TROUBLESHOOTING
Causes/Action
- Protection against frequent starting. Wait for 3 to 4 minutes
for the compressor to start operate.
- Power failure, or the fuse need to be replaced.
- The power plug is disconnected.
- It is possible that your delay timer has been set
incorrectly.
- The air lter is dirty.
- The air suction and discharge are clogged.
- The regulated temperature is not high enough.
(applicable for auto-fan mode only)
- Odors may be caused by cigarettes, smoke particles,
perfume etc. which might have adhered onto the coil.
- This is caused by air humidity after an extended long period
of operation.
- The set temperature is too low, increase the temperature
setting and operate the unit at high fan speed.
- Switch off unit and call local dealer / serviceman.
1-23
Period
At least once every 2
weeks.
More frequently
when necessary.
At least once every 2
weeks.
More frequently
when necessary.
When necessary.
Advertisement
Table of Contents
