Philips SpeedPro Max Aqua User Manual page 10

English
10
To remove the rechargeable battery, follow the instructions below.
1 Disconnect the appliance from the wall socket and let it run until the motor stops.
2 Remove the dust container from the appliance (Fig. 5).
3 Undo the three screws that fix the battery holder to the housing of the appliance (Fig. 6).
4 Pull the battery holder out of the appliance (Fig. 7).
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you are
unable to solve the problem with the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Center in your country.
Problem
The appliance does not
work when I push the
button.
The appliance suddenly
stops working.
The appliance has a lower
suction power than usual.
Dust escapes from the
appliance.
Possible cause
When the battery is empty,
'00' flashes on the display.
You have to push the slider
forward to switch on the
appliance.
When there is a problem, the
buttons will not respond and
the screen will remain blank.
The filter and the cyclone are
dirty.
You have not attached the
dust container lid properly to
the dust container. You have
not attached the dust
container to the appliance
properly. In both cases, there
will be a loss of suction power.
The filter is dirty.
The filter is not present in the
appliance.
Solution
To charge the battery, connect the
appliance to the charging base or attach
the handheld vacuum cleaner directly to
the magnet on the charging base.
Push the slider forward to setting 1 to
switch on. Increase the suction power
further by pushing the slider to setting 2 or
select the turbo setting to clean very dirty
patches at the highest suction power.
Connect the appliance to the charging
station or attach the handheld vacuum
cleaner directly to the magnet on the
charging station. Check the display. Once
the appliance starts charging, you may
continue to use the appliance as usual. If
an error code appears, you can find its
meaning in this booklet (see 'Error codes').
Clean the filter and the cyclone. The filter
light lights up after several hours of use to
indicate that you have to wash the sponge
filter. Make sure that you wash the sponge
filter at least once a month if you use the
appliance regularly.
Make sure that you attach the dust
container lid to the dust container and the
dust container to the appliance properly.
Clean the filter.
Make sure that the filter is in the appliance
and assembled correctly.