Sony UP-860 Operating Instructions Manual page 6

[1]
[2]
Rear panel
REMOTE connector (stereo minijack)
Connect to the FS-20 foot switch (not supplied) for
controlling print operation from a distance.
GAMMA selector
This selector changes the print mode to that for high-
density printing paper . This selector is effective when
the PAPER DIP switch is set to TYPE IL.
I : Soft graduation
Il: Standard
II: Hard graduation
DIP switches ©
These switches set the print modes and functions.
VIDEO IN (video input) connector (BNC type) ©
Connect to the video output connector of the video
equipment.
VIDEO OUT (video output) connector (BNC type)
©
Connect to the video input connector of the video
monitor. The output signal type depends on the setting
of the THRU/EE selector.
[6
AC IN (AC power input) connector ©
Connect to a wall outlet, using the supplied AC power
cord.
D ADJ (fine adjusting) control
Usually, there is no need to use this control. Use it
only when you have to make a fine adjustment of the
density when you cannot control the brightness using
the BRIGHT contro}.