Table of Contents
Advertisement
8
If you have a metric socket set, that's great, otherwise, the tools fisted will do just fine. We
recommend this order of events in the assembly process. This is by no means the "only" way to
assemble this unit, merely a suggestion.
Order of Assembly
1. Stand
2. Motor
3. Unit to Stand
4. Wiring
5. Align Pulleys
6. Table
7. Fence Assembly
8. Total Unit Check
A. STAND ASSEMBLY
1. Begin stand assembly by placing all the stand parts and bolt bag within easy reach to ease
assembly.
2. Flip stand top (Pt.#86) upside down and swing motor base (Pt.#89) so that the base rests on
top of the two adjusting screws. Locate one nut and washer below base and the other above.
Just hand tighten for now. (See Figure 2.)
Figure 2 Shows stand upside down for ease of assembly.
3. Mount motor onto motor base at this time. Secure with the four 5/16"x18x%'' L Hex bolts,
washers and nuts provided. Tighten snuggly for now.
4. Attach the four legs (Parts #82) to the top of the stand using the 5/16''x1
QxVi"
L RND HD bolts,
washers and nuts provided. Do not tighten down bolts completely at this time.
5. Attach the four braces (Parts #84,85) to the legs and secure with 5/16"x18x1^" L RND HD
bolts and washers.
Note: Do not fasten the last brace to the pulley side of the stand at this time. This will enable
you to have an unobstructed assembly area and room to align pulleys.
Flip stand right side up and wiggle stand around so it is level and symmetrical. Finally, tighten
all of the stand bolts.
6
.
Advertisement
Table of Contents
