Stand Assembly - Grizzly G0555 Instruction Manual

7. Place the 2 top stand braces into the under-
side of the stand top.
8. Line the braces up with the holes and secure
only the end shown in Figure 10 with (2) M8-
1.0 x 16 carriage bolts and (2) M8-1.0 flange
nuts from the hardware bag. The holes in the
other end of the brace must be left open to
mount the bandsaw unit.
Figure 10. Installing braces on stand top.
9. Turn the stand assembly upright and secure
the stand top to the stand assembly with the
remaining (8) M8-1.0 x 16 carriage bolts and
(8) M8-1.0 flange nuts from the hardware
bag. The stand assembly is now complete
and should look similar to Figure 11.
Figure 11. Stand top installed on

stand assembly.

-14-
10. Place a level across the stand top as shown
in Figure 12 and adjust the feet as neces-
sary to make the stand level. Turn the level
90˚ and adjust the stand to be level again.
Repeat these two adjustments until the stand
is level in both directions.
Figure 12. Leveling stand.
11. Tighten the hex nuts on the feet, so that they
are against the underside of the stand and
will lock the feet in place to keep the stand
level.
G0555 14" Ultimate Bandsaw