Table of Contents
Advertisement
9
7. Place the bandsaw proper on the stand at this time (See Figure 3).
Important: This unit is extremeiy heavy. If you have any doubts as to your lifting capabilities,
get assistance.
8. Secure with the four
W
L Hex Bolts, washers and nuts provided. Tighten securely.
Figure 3 Shows unit on stand.
9. The electrical line from the switch can be fed through the plastic grommet on top of the stand
and secured.
Note: Line ends are your incoming power lines from the switch and are to be attached to the
motor. (See diagram in back of manual.)
Figure 4 Shows cord arrangement to motor.
Advertisement
Table of Contents
