Panasonic Quasar Palmcorder VM-L451 Operating Instructions Manual page 18

Playing Back Recordings
Hayt^pl^^liBwingra
Connect Camcorder to a TV to view
playback or recordings in progress.
Before you begin...
* Connect Camcorder to power source.
• Make all TV-Camcorder connections.
1 Set POWER to:
VCR
-» view playback.
CAMERA
-* view picture as it is
recorded.
2
Turn TV ON and set to LINE INPUT.
See TV owner's manual.
3
Begin playback or recording.
CATV System Installer
This reminder is provided to call the CATV system installer's attention to Article 820-40
of the NEC in USA (and to the Canadian Electrical Code in Canada) that provides
guidelines for proper grounding and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building, as close to the point of cable
entry as practical.
Remove Battery lid
///£>
and insert AA
battery.
* Do not reverse
P°larity-
• Replace battery -J
when tape loading/unloading takes
longer than usual.
3
Slide RELEASE
and wait for lid to
Push cassette
out through
hole in bottom of
PlayPak with
your finger.
Turn KUSH cassette
Tape Wheel in
direction of arrow
to
take up any slack.
Slide RELEASE
to
open cassette lid.
Insert the KB50
cassette
with the
window up and on the
left,
then snap lid shut.
Do not obstruct cassette reel while loading.
Allow PlayPak Load Detector to fully retract before
using in VHS VCR.
Load Detector
For assistance, please call: 1-800-211-PANA(7262) or send e-mail to: consumerproducts@panasonic.com