Digital Zoom.25; Digital Electronic Image Stabilization (E.i - Panasonic Quasar Palmcorder VM-L451 Operating Instructions Manual

Digital Zoom
Before you begin...
• Connect Camcorder to power source.
• Set POWER to CAMERA.
1 Press P. ZOOM.
Digital Zoom mode (150x maximum).
The Higher digital magnification levels
may cause picture distortion.
2 Hold down "T" on POWER ZOOM.
Digital Zoom starts when normal zoom
reaches maximum
(20x).
• Zoom level appears in EVF or LCD
monitor.
• POWER ZOOM switch controls digital
zoom level.
• Normal zoom resumes when level falls
to 20x.
3 Press D. ZOOM
to turn off Digital Zoom
so no indication appears.
Digital Electronic Image Stabilization (E.I.S.)
Helps stabilize picture when recording in
unstable situations.
Before you begin...
• Connect Camcorder to power source.
• Set POWER to CAMERA.
1 Press EIS
to display "EIS" in the EVF or
LCD monitor.
• Image becomes slightly enlarged and
shutter speed auto-adjusts from 1/80 to
1/350 according to brightness.
• Use High Speed Shutter (page 22) if
needed. Shutter speed setting remains
after EIS is canceled.
2
Press
E]S
again
to cancel when not in
use.
E.I.S. may not function during...
• extreme Camcorder movement.
• recording of subjects with distinct
horizontal or vertical stripes.
• low light situations (EIS indicator flashes).
• intense fluorescent lighting situations.
• recording of very fast motion.