Camera Recording (Basic, Stand-By, Programmed Recording) - Panasonic PV-L352-K Operating Instructions Manual

Recording via EVF or LCD
Monitor
View recording scene on EVF (Electronic
Viewer Finder) or LCD (Liquid Crystal
Display) monitor.
1
3
BRIGHT
ADJUSTMENT
CAUTION :
Rotating partially open LCD
monitor may block cassette door
and damage Camcorder body.
4
5
Note:
• When Camcorder is aimed at excessively
bright objects, or bright lights, a vertical
bar may appear in the picture. This is
normal for the CCD pick-up. Try to avoid
this when possible.
• Using LCD monitor reduces battery
operation time. Return LCD monitor to
locked position when not in use.
03.L552-K(E)Basic p17-19
Camera Recording
Before you begin...
• Connect Camcorder to power source.
• Insert cassette with record tab (page 11).
1
Press LCD-OPEN to unlock the LCD
monitor. Swing LCD monitor fully open
and adjust viewing angle.
• If you want to record using EVF, close
and lock LCD monitor.
2
Set POWER to
3
CAMERA.
• Be sure POWER
VISION
ADJUSTMENT
is fully turned to
CAMERA position.
• EVF or LCD monitor
turns on/off by the POWER switch.
• Both EVF and LCD monitor turn on
when LCD is at 180° (see above left).
This allows both you and the subject to
view the recording.
3
LCD : Press BRIGHT
Built-in
Microphone
EVF : Look into EVF and adjust
4
2 6
,
Hold down TAPE SPEED for about 1
second to change tape speed to SP/SLP
(page 11).
5
Press RECORD/
PAUSE to start or
pause recording.
6
Set POWER to
OFF when finished.
• To remove the cassette, slide the
TAPE EJECT switch (page 11).
17
EVF or LCD Monitor
(Record/Pause mode)
ADJUSTMENT
to adjust LCD
monitor
brightness level.
VISION ADJUSTMENT to your
eyesight.
Tape speed
EVF or LCD Monitor
(Record mode)
02.1.28, 2:27 PM
17