Camera Recording (Basic, Stand-By, Programmed Recording) - Panasonic Palmcorder PV-L354-K Operating Instructions Manual

Recording via EVF or LCD
Monitor
View recording scene on EVF (Electronic
Viewer Finder) or LCD (Liquid Crystal
Display) monitor.
1
CAUTION
Rotating partially open LCD monitor
may block cassette door and damage
Camcorder body.
VISION
3
ADJUSTMENT
To adjust LCD BRIGHT
A
Press MENU for
MENU mode.
Press UP or DOWN
to select
LCD BRIGHT .
B
Press M.FOCUS for
LCD BRIGHT
SETTING menu.
Press UP or DOWN
to adjust LCD monitor
brightness level.
03.L354K Basic p17-19
Camera Recording
Before you begin...
• Connect Camcorder to power source.
• Insert cassette with record tab (page 11).
1
Press LCD-OPEN to unlock the LCD
monitor. Swing LCD monitor fully
open and adjust viewing angle.
2
Set POWER to
CAMERA.
• Be sure POWER
is fully turned to
CAMERA position.
• EVF or LCD monitor
turns on/off by the POWER switch.
• Both EVF and LCD monitor turn on
when LCD is at 180° (see above left).
4
A B
, ,
This allows both you and the subject
to view the recording.
3
LCD : Adjust LCD monitor brightness
EVF : Look into EVF and adjust
Built-in
Microphone
4
2 6
Set REC MODE to "SP" or "SLP" in
,
the CAMERA MODE Menu (page 13).
5
5
Press RECORD/PAUSE to start or
pause recording.
6
Set POWER to OFF when finished.
• To remove the cassette, slide the
TAPE EJECT switch (page 11).
Note:
• When Camcorder is aimed at excessively
bright objects, or bright lights, a vertical
bar may appear in the picture. This is
normal for the CCD pick-up. Try to avoid
this when possible.
• Using LCD monitor reduces battery
operation time. Return LCD monitor to
locked position when not in use.
17
EVF or LCD Monitor
(Record/Pause mode)
level.
See To adjust LCD BRIGHT
VISION ADJUSTMENT to your
preference.
04.1.6, 0:23 PM
left.
17