Table of Contents
Advertisement
Troubleshooting
Problem
Fills with the wrong water
temperature.
Load is wet at the end of
a cycle.
Leaks water.
Items still wrinkled after
Wrinkle Prevent (Wrinkle
AwayWrinkle Release)
78
English
Untitled-14 78
• Fully open both taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps. Flush water
lines.
• Make sure the water heater is set to supply a minimum of 49 °C hot
water at the tap. Also, check the water heater capacity and recovery
rate.
• Disconnect the hoses and clean the mesh filter. The mesh filter may be
clogged.
• While the Laundry Combo fills, the water temperature may change
as the automatic temperature control feature checks incoming water
temperature. This is normal.
• While the Laundry Combo fills, you may notice just hot and/or just cold
water going through the dispenser when cold or warm temperatures are
selected. This is a normal function of the automatic temperature control
feature as the Laundry Combo determines the water temperature.
• Use the High or Extra High spin speed.
• Use high efficiency (HE) detergent to reduce oversudsing.
• Load is too small. Small loads (one or two items) may become
unbalanced and not spin completely.
• Make sure the drain hose is not kinked or clogged.
• Make sure the door is properly closed.
• Make sure all hose connections are tight.
• Make sure the end of the drain hose is correctly inserted and secured to
the drain system.
• Avoid overloading.
• Use high efficiency (HE) detergent to prevent oversudsing.
• Check the drain hose.
-
Make sure the end of the drain hose is not placed on the floor.
-
Make sure the drain hose is not clogged.
• Small loads of 1 to 4 items work best.
• Load fewer items. Load similar-type items.
• Take out the items immediately after drying is complete.
Action
2024-02-07
3:53:43
Advertisement
Table of Contents
