Table of Contents
Advertisement
Troubleshooting
If a problem persists, contact a service center. The number of the service center is on the label attached to
the product.
Checkpoints
If you encounter a problem with the Laundry Combo, first check the table below and try these suggestions.
Problem
Does not start.
Water supply is
insufficient, or no water is
supplied.
After a cycle, detergent
remains in the detergent
drawer.
Untitled-14 75
• Make sure the Laundry Combo is plugged in.
• Make sure the door is properly closed.
• Make sure the water taps are open.
• Tap
to start the Laundry Combo.
• Make sure Lock is not activated.
• Before the Laundry Combo starts to fill, it will make a series of clicking
noises to check the door lock and will do quick drain.
• Check the fuse or reset the circuit breaker.
• Check if power is supplied properly.
• Low voltage detected.
-
Check if the power cord is plugged in.
• Make sure laundry is not caught in the door.
• Clean the filter.
• Fully open the water tap.
• Make sure the door is properly closed.
• Make sure the water supply hose is not frozen.
• Make sure the water supply hose is not kinked or clogged.
• Make sure there is sufficient water pressure.
• Make sure that the cold water tap and the hot water tap are properly
connected.
• Clean the mesh filter as it may be clogged.
• Make sure the Laundry Combo is running with sufficient water pressure.
• Make sure the detergent is added to the center of the detergent drawer.
• Make sure the rinse cap is inserted properly.
• If using granular detergent, make sure the detergent selector is in the
upper position.
• Remove the rinse cap and clean the detergent drawer.
Action
English 75
2024-02-07
3:53:43
Advertisement
Table of Contents
