Table of Contents
Advertisement
en Before using for the first time
Before using for the first time
9 Before using for the
first time
Before using for the first time
9.1 Performing initial start-up
On initial start-up or after a reset to
the factory settings, you will need to
make settings. The display shows the
settings for initial start-up.
Tip: Connect your appliance to a mo-
bile device. You can conveniently
change all settings via the
Home Connect app.
Requirement: The appliance has
been installed and connected.
→ Page 12
Add special salt. → Page 27
1.
Add rinse aid. → Page 28
2.
Switch on the appliance.
3.
The display shows the settings for
a
initial start-up.
Press
repeatedly until the display
4.
shows the required setting.
Note: If you select Initial start-up
Home Connect here, make further
settings using the Home Connect
app on your mobile device.
You can change the settings for
initial start-up and other Basic set-
tings → Page 37 on the appliance
at any time or use the Home Con-
nect app on your mobile device.
10.1 Overview of water hardness settings
You can find an overview of the water hardness values that can be selected
here.
You can find out how hard your water is from your local water company or by
using a water hardness tester.
Water hardness
°E
0 - 8
9 - 10
26
Hardness range
Soft
Soft
Press
or
5.
display shows the right value.
You can change several settings.
To save the settings, press
6.
approx. 3 seconds.
Add detergent → Page 29.
7.
Start the Programme with the
8.
highest cleaning temperature
without tableware.
To remove any marks from water
or other residues, we recommend
you operate the appliance without
tableware before using it for the
first time.
Water softening system
10 Water softening sys-
tem
Hard water leaves limescale on the
Water softening system
tableware as well as the washing
tank, and parts of the appliance may
become blocked.
To ensure good dishwashing results,
you can treat the water with special
salt and the water softening system.
To avoid damage to the appliance,
water with a hardness above 9 °E
must be softened.
mmol/l
0 - 1.1
1.2 - 1.4
repeatedly until the
Setting value
0 - 8
9 - 10
for
Advertisement
Table of Contents
