Basket Heights; Before Using For The First Time; Performing The Initial Configura- Tion - Siemens SN45ZS70CS Information For Use

en Before using for the first time
To stop the stemware falling out,
make sure the stemware basket
cannot tip over.
→ "Arrange tableware", Page 32
Unloading stemware basket
Note: Observe the information on
how to unload tableware.
→ "Removing tableware", Page 33
Take the stemware basket by the
1.
handle out of the bottom basket.
Pull up the rotating fixing arms
2.
and turn anticlockwise

Basket heights

Set the baskets at the right height.
Appliance height 81.5 cm with cutlery drawer
Level
1 max. ø
2 max. ø
3 max. ø

Before using for the first time

Before using for the
first time
Before using for the first time
Performing the initial config-
uration
On initial start-up or after a reset to
the factory settings, you will need to
make settings.
Tip: Connect your appliance to a mo-
bile device. You can conveniently
change all settings via the
Home Connect app.
→ "Home Connect quick start",
Page 37
Requirement: "The appliance has
been installed and connected."
→ Page 12
24
⁠ .
Top basket
16 cm
18.5 cm
21 cm
Take the stemware out of the
3.
stemware basket
Bottom basket
30 cm/"31 cm" → Page 21
27.5 cm
25 cm
"Add special salt." → Page 25
1.
"Add rinse aid." → Page 27
2.
"Switch on the appliance."
3.
→ Page 33
"Setting the water softening sys-
4.
tem." → Page 25
"Set the amount of rinse aid to be
5.
dispensed." → Page 28
"Add detergent" → Page 28.
6.
Start the Programme with the
7.
highest cleaning temperature
without tableware.
To remove any marks from water
or other residues, we recommend
you operate the appliance without
tableware before using it for the
first time.
Tip: You can change these settings
and other "Basic settings"
→ Page 35 at any time.
⁠ .