Table of Contents
Advertisement
Note for test institutes
Energy efficiency class according to EN 60350-1
The energy efficiency class is determined in accordance with EN 60350-1.
Energy efficiency class: A+
Please observe the following when conducting testing:
- Testing is undertaken using the
- Select the
Lighting
- Select the
Movement sensor
"Movement sensor").
- Only accessories that are required for testing should be in the oven compartment
during tests. Do not use any other available accessories such as FlexiClip run-
ners.
- The thermocouples must be inserted through the door seal for the test. To do
this, pull the door seal out of its groove and pierce it twice. Insert the thermo-
couples through the two holes in the door seal. Then press the door seal firmly
back into the groove so that it fits snugly and evenly all over.
- In the next step, remove the floor filter and pour water into the drain until the sur-
face of the water is visible.
- An important pre-condition for determining the energy efficiency class is that the
door is tightly shut during testing.
Depending on measurement devices used, the functioning of the door seal can
be affected to a greater or lesser extent. This has a negative impact on the test
results.
176
Eco Fan heat
|
"On" for 15 seconds
|
Switch the light on
operating mode.
setting (see "Settings" – "Lighting").
|
setting (see "Settings" –
Off
Advertisement
Table of Contents
