Advertisement
ADJUSTING DISTANCE (CONTINUED)
(1)
(2)
(1) Constant speed cruising when there are no vehicles ahead
The vehicle travels at the speed set by the driver. If the set vehicle speed is
exceeded while driving down a hill, the set vehicle speed display will blink and
a buzzer will sound.
(2) Deceleration cruising and follow-up cruising when a preceding vehicle
driving slower than the set vehicle speed is detected
When a slower vehicle is detected running ahead of your vehicle, the vehicle
automatically decelerates and if a greater reduction in vehicle speed is
necessary, the brakes may be applied (the brake lights will come on at this
time). The vehicle is controlled to maintain the vehicle-to-vehicle distance set by
the driver, in accordance with changes in the speed of the preceding vehicle.
If vehicle deceleration is not sufficient and the vehicle approaches the vehicle
ahead, the approach warning will sound.
(3) Acceleration when there are no longer any preceding vehicles driving
slower than the set vehicle speed
The vehicle accelerates until the set vehicle speed is reached and then resumes
constant speed cruising.
(4) Starting off
If a preceding vehicle stops, the vehicle will also stop (controlled stop). After
the preceding vehicle starts off, pressing the "RES" switch or depressing the
accelerator pedal will resume follow-up cruising (start off operation). If a start off
operation is not performed, the controlled stop will continue.
Note: When your vehicle is too close to a vehicle ahead, and sufficient automatic
deceleration via the cruise control is not possible, the display will flash and the
buzzer will sound to alert the driver. An example of this would be if another driver
cuts in front of you while you are following a vehicle. Depress the brake pedal to
ensure an appropriate vehicle-to-vehicle distance.
(3)
(4)
73
Advertisement
