Table of Contents
Advertisement
To align the appliance, turn the ap-
2.
pliance feet. Check that the appli-
ance is level using a spirit level.
All appliance feet must stand firmly
on the ground.
Use a WAF 17 wrench to tighten
3.
the lock nuts against the housing
until they are hand-tight.
In doing so, hold the foot tight and
do not adjust its height.
Before using for the first time en
Before using for the first time
5 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
5.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
Turn the programme selector to
1.
Cottons 90°.
Close the door.
2.
Pull out the detergent drawer.
3.
Add washing powder containing
4.
oxygen bleach to compartment II.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
Push in the detergent drawer.
5.
Press
Start/ Reload to start the
6.
programme.
a The display shows the remaining
programme duration.
a After the programme has ended,
the display shows: End.
17
Advertisement
Table of Contents
