Table of Contents
Advertisement
en Before using for the first time
Before using for the first time
6 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
Press .
1.
The switch-on process takes a few
seconds.
Set the Bomull 90°C (Cotton
2.
90°C) programme.
Close the door.
3.
Pull out the detergent drawer.
4.
Add washing powder that contains
5.
a bleaching agent to the manual
dosing compartment.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
Push in the detergent drawer.
6.
Press
to start the programme.
7.
a The display shows the remaining
programme duration.
a After the programme has ended,
the display shows: "End".
20
Start the first wash cycle or press
8.
to put the appliance in standby
mode.
→ "Basic operation", Page 32
Advertisement
Table of Contents
