Table of Contents
Advertisement
Before using for the first time
6 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
Press .
1.
The switch-on process takes a few
seconds.
Set the 槽潔淨 programme.
2.
Close the door.
3.
Pull out the detergent drawer.
4.
Add washing powder containing
5.
oxygen bleach to the manual dos-
ing compartment.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
Push in the detergent drawer.
6.
Press
to start the programme.
7.
a The display shows the remaining
programme duration.
a After the programme has ended,
the display shows: "End".
Before using for the first time en
Start the first wash cycle or press
8.
to put the appliance in standby
mode.
→ "Basic operation", Page 34
21
Advertisement
Table of Contents
