Table of Contents
Advertisement
Fault
Creasing.
Water is leaking out at
the water inlet hose.
Water is leaking out at
the water outlet hose.
Water is leaking from
below the door.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
Residual water is
present in the com-
partment
.
Fabric softener re-
mains in the detergent
drawer.
Cause and troubleshooting
A high spin speed is selected.
The next time you run a wash cycle, set a lower
▶
spin speed.
The load is unsuitable.
Observe the programme's maximum load capacity.
▶
→ Page 25
Prepare the laundry. → Page 29
▶
The laundry lies in the drum for too long after drying.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Easy Care fabrics have been dried for too long.
Change the dryness level. → Page 32
▶
The water inlet hose is not correctly connected or is
damaged.
Check the installation of the water inlet hose.
▶
→ Page 13
Replace the water inlet hose if it is damaged.
The water outlet hose is not connected correctly or is
damaged.
Check the installation of the water outlet hose.
▶
→ Page 13
Replace the water outlet hose if it is damaged.
Dirt on the door or seal causes leaks.
Clean the door and the seal.
▶
There is too much detergent or fabric softener in the
detergent drawer.
When dosing, observe the marking in the detergent
▶
drawer.
Insert in compartment
Clean the detergent drawer. → Page 34
▶
The use of fabric softener is not supported for the se-
lected programme.
Check whether the use of fabric softener is suppor-
▶
ted for the selected programme. → Page 25
Troubleshooting en
is blocked.
43
Advertisement
Table of Contents
