Table of Contents
Advertisement
Fault
"E:30 / -10",
"H:95" and End.
"E:30/-20"
Heavy foam build-up.
flashes.
Cause and troubleshooting
or
The filters in the water inflow are blocked.
Clean the filters in the water inflow.
▶
The water pressure is low.
Check whether the tap has sufficient water pres-
▶
sure.
The water level measuring system is defective.
With this error message, the appliance starts a drain-
ing process.
Wait approx. 5 minutes until the draining process
1.
ends.
Restart the appliance.
2.
If required, start the draining process again.
If the fault persists, call customer service.
3.
→ Page 46
Critical malfunction.
Turn off the water tap.
▶
With this error message, the appliance starts a drain-
ing process.
Wait approx. 5 minutes until the draining process
1.
ends.
Restart the appliance.
2.
If required, start the draining process again.
If the fault persists, call customer service.
3.
→ Page 46
Detergent dosage is too high.
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
Additional water has been added.
Do not add any extra water to the appliance while it
▶
is operating.
Detergent dosage is too high.
Mix one tablespoon of fabric softener with 0.5 litres
▶
of water and pour the mixture into compartment II
(not for outdoor clothing, sportswear or items
stuffed with down).
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
The door is not completely closed.
Ensure that there is no laundry trapped in the door.
1.
Close the door.
2.
Troubleshooting en
39
Advertisement
Table of Contents
